To replace the factory radio Ford 6000CD or others from this series, all you need is matching parts from the kit. There are two holes left and right around the radio, the matching release tabs are included in the set. Press the clips on both sides into the holes and then pull out. The radio is connected at the back with the antenna cable and the vehicle cable.
Disconnect the cables they are only engaged. The new radio can be installed with the radio panel. In this Ford Transit fit no double DIN car radios. The antenna adapter must be configured to DIN and the appropriate radio cable with ISO ends that fits into the new car radio at the back.
This car stereo fitting kit is designed to fit the following vehicle(s);
- Ford Transit 1996 – 2006 color black
These adaptors will allow you to remove your original factory headunit and replace it with an aftermarket unit.
The kit includes the following parts;
- Fascia plate – converts dashboard to fit new stereo
- ISO adaptor lead – converts wiring to common ISO type
- Aerial adaptor – converts aerial connection
Radio dash kit: Facia Panels aid easy fitment and hold your new aftermarket unit securely within your dash and are designed to keep the factory fitted look of your vehicle.
ISO adaptor lead: The ISO harness allows you to convert the factory wiring to the ISO connector of the aftermarket headunit. Enabling it to be fitted without cutting any of the original wiring of the vehicle.
Aerial adaptor: Aerial adaptor may be required to complete the installation. Without the right aerial adapter you have a poor radio reception.
If you have purchased a new stereo then you will usually need these parts to fit it.
The parts are specifically designed to fit the vehicle(s) listed and make fitting the new stereo much easier.